Fits 3D Printed Bigger bonets of NewHolland TM models 38
✅ Beste prijs gegarandeerd
✅ 1 jaar fabrikарантie
🛍️ Koop nu met vertrouwen!
Fits 3D Printed Bigger bonets of NewHolland TM models
38.5mm X 8.2mm
we can make difrent sizes on requst
Professional pre-cut, overig thin and waterproof stickers, ready for use.
These stickers are also very suitable for labeling convex surfaces and have a high adhesive
strength.
You can apply these stickers with the “Dry” or “Wet” method.
Dry method:
-Apply decal at room temperature
-Clean & dry the surface
-Remove the excess foil from the delivered sticker
-“Remove” the pre-cut decal from the decal sheet and place it on your model
-Press the sticker firmly to activate the pressure sensitive adhesive;
This is fully cured after 48 hours
Wet Method:
-Apply to model at room temperature
-Clean & dry the surface
-Mix 1 drop of soap with lime-free water (boiled or distilled) in a container
or plant sprayer
-Remove the excess foil from the supplied sticker sheet
-Spray the surface to be sticker
Beoordelingen
Er zijn nog geen beoordelingen.